Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. Stretch a piece of string along the hedge at this
height.
2. Cut the hedge immediately above this string.
3. Cut the side of a hedge until it will be narrower at the
top. More of the hedge will come into view in that
way.
7
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Pull the mains plug out of the socket before maintenance.
7.1
CLEAN THE MACHINE
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
7.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
8
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure that the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
CAUTION
CAUTION
WARNING
WARNING
NOTE
English
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
9
TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
There is too much
noise and/or vibra-
tion during opera-
tion.
10
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight
8
Possible cause
Solution
Cord not plugged
Plug in cord.
in.
Cord or switch is
Have cord or
damaged.
switch replaced.
1. Immediately
stop the ma-
chine.
The machine has
2. Disconnect the
damage.
plug from
power source.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Disconnect the
plug from power
The blades are
source then clear
blocked.
blockage from the
blades.
1. Stop the ma-
chine.
2. Disconnect the
plug from
power source.
The parts are loos-
en.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
4A, 120 V
3200 (±10%) SPM
22''
3/4''
2.6 kg (5.7 lbs.)
Publicidad
