Pfister KENZO 49 Serie Instrucciones De Montaje página 2

Idiomas disponibles

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long

trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated

instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Pfister

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

This product has been designed for use with the Price Pfister 0W8-01 Wallmout

Valve Body. It will not work with any other product.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE Plumber's Tape

• Plumber's putty

• Adjustable wrench

• Pliers

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Spout Body

B Handles (2x)

D Set Screw

E Valve Flange (2x)

If any of these items are missing, please contact Price Pfister Consumer Service at

1-800-Pfaucet (1-800-732-8238).

ENGLISH

• Slotted screwdriver

• Flashlight

C Spout Flange

F Seal Base (2x)

FINISHED WALL

5 VALVE BODY ADJUSTMENT

Remove all Plasterguards (5A). Loosen Collet Nut (5B) from Main Body (5C). Pull

the Spout Tube (5D) from the Main Body (5C) to the maximum position. Using the

end with the feet of Installation Tool (5E), push Outlet Tube (5D) in until Tool Feet (5F)

sit flat with Wall Surface as shown. Tighten Collet Nut (5B) by using the other end of

Installation Tool (5E) as shown.

FINISHED WALL