Publicidad
Idiomas disponibles
Idiomas disponibles
Pairing the TV to the Samsung Smart Remote
Installing batteries into the Samsung Smart Remote (Q800T, Q900T)
1. Press the
button at the top rear of the Samsung Smart Remote. The body will pop out slightly from the body
cover.
2. Turn the remote over, and then slide the body of the remote upwards until the battery compartment is revealed.
3. If there are batteries in the remote, press the r and l buttons on both sides of the battery compartment to
remove the existing batteries.
4. Insert two new batteries (1.5V AAA type) into the battery compartment making sure that the batteries' polarities
(+, -) are oriented correctly. When done, slide the body of the remote until it is nearly in its original position.
5. Turn the remote over, press and hold the
into place.
• Alkaline batteries are recommended for longer battery life.
Installing batteries into the Samsung Smart Remote (Q700T)
To install the batteries (1.5V AA type), push the rear cover open in the direction of the arrow at the bottom of the
illustration, and then insert the batteries as shown in the figure. Make sure that the positive and negative ends are
facing in the correct direction. Close the rear cover as shown.
• Alkaline batteries are recommended for longer battery life.
English - 12
When you turn on the TV for the first time, the Samsung Smart Remote pairs to the TV
automatically. If the Samsung Smart Remote does not pair to the TV automatically,
point it at the remote control sensor of the TV, and then press and hold the buttons
labeled
and
as shown in the figure on the left simultaneously for 3 seconds or
more.
1
button on the top rear, and then slide the body of the remote down
2
2
1
Publicidad
