Operation (continued)
Adjusting the DUALBRITE
7
Switch
The "DUALBRITE" switch determines the amount of
time the lights stay on at a reduced light level after
sundown. Switching this setting to "OFF" will not
effect the "ON-TIME" setting.
Set the "DUALBRITE" switch to OFF, 3 hours, 6
hours, or dusk-to-dawn (sunset to sunrise).
ON-TIME
DUAL BRITE
TEST 1 5 20
OFF 3 6 DUSK TO
MINUTES
HOUR
9
Using Manual Mode
Manual mode overrides the motion sensor (C) and
"ON-TIME" control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (C) will reset to motion
sensing mode after 6 hours or sunrise, whichever
comes first. Manual mode can be toggled on and off
using a wall switch.
To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
C
®
DAWN
Adjusting the LAMP MODE
8
Switch
The "LAMP MODE" switch determines the way the
lights will turn on when motion is detected.
Security ("NORMAL") - Light comes on instantly.
BulbSaver ("SOFT") - Light comes on dim and
gradually increases to full brightness. When the
light turns off it will gradually dim to half-bright,
pause, and then will continue dimming until the
light turns off.
AlertFlash ("FLASH") - Light flashes on then off
twice before turning on full brightness.
Set the "LAMP MODE" to "NORMAL", "SOFT",
or "FLASH" position.
RANGE
LAMP MODE
MIN
NORMAL SOFT FLASH
Turn the switch
OFF for 3 to 4
seconds
9
Please contact 1-866-308-3976 for further assistance.
C
MAX
Turn the
switch
back ON
HOMEDEPOT.com