Amate Audio B Serie Manual De Usuario página 4

B Series
If you are using a cabinet which includes in-built transformer, use the switch to
select the position that corresponds to the required power.
Fig.3. B5/T & B6/T power selector
If you are working in 100V line mode and you choose (i.e) 40W/250Ω selector, then
that (40W) will be the maximum power that will accept the cabinet.
If you are using an amplifier that gives 1200W, then the maximum number of cabinets
that you can use will be 30 (1200W/40W).
If you are using an amplifier that gives 2000W, then the maximum number of cabinets
that you can use will be 50 (2000W/40W).
3. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinets, it is strongly recommended to read
carefully the following advices.
Fig.4. Flying placement
3.2. Flying
Only experienced people should fly speaker cabinets. Extreme care should be taken
to assure the load bearing capabilities of the structures where the cabinets will be
placed. Hanging hardware (as chains, eyebolts, lock pins...) should be regularly
inspected and replaced if in doubt.
4
Power Impedance
(100V line)
5W 2kΩ
10W 1kΩ
20W 500Ω
40W 250Ω
3.1. Placement
The cabinets should be located in a high
position, slightly
audience. If the
located too low, the listeners at the end
of the room will not hear a good sound
quality.
Sept 2017
inclined to the
loudspeakers are
Amate Audio