AOSmith CLARYUM AO-US-100-R Manual Para El Reemplazo página 3

1
Remove dispenser from filtration dock. With
filtration dock facing forward, open top cover
by rotating it a quarter-turn to the right until
the top cover lifts off the filtration dock.
3
Drop the filter replacement
into the opening on the dock
with the o-rings facing up.
7
Once the filter has been replaced and the top
cover is fully locked into filtration dock, fill
dispenser with cold water and place back onto
dock.
2
Remove used filter from top cover by pulling
down on the filter.
4
After dropping the filter
replacement into the dock
opening, push the reset
button located on the top
of the dock with a sharp
pointed object. This will reset
the filter status light on the
system.
8
Hold dispenser button down until all water has
filtered through the system.
NOTE: Do not drink flushed water.
INSTALLATION STEPS AO-CWM
5
Place the top cover on the
dock. Press firmly and rotate
the top cover a quarter-turn
to the left until fully locked
in. Ensure both tabs on the
top cover are aligned with
the dock.
RESET
WATER DISPENSE BUTTON
3