D-Link DIR-827 Guía De Instalación Rápida página 4

TROUBLESHOOTING
SET-UP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DIR-827 ROUTER WITHOUT THE CD, OR CHECK MY
WIRELESS NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- connect your pc to the router using an ethernet cable.
- open a web browser and enter the address http:// dlinkrouter or http://192.168.0.1
- the default username is 'admin'. the default password is '' (leave the field blank).
- If you have changed the password and can not remember it, you will need to reset the router to
set the password back to '' (leave the field blank).
2. HOW DO I RESET MY DIR-827 ROUTER TO FACTORY DEFAULT SETTINGS?
- ensure the router is powered on.
- press and hold the reset button on the rear of the device for 20 seconds.
note: Resetting the router to factory default will erase the current configuration settings. to re-
configure your settings, log into the router as outlined in question 1, then run the setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- every pc that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document, this important
information for future use.
4. WHY CAN I NOT GET AN INTERNET CONNECTION?
- For cable users make sure clone mac address option is ticked during Wizard installation
(or enter the registered mac) and make sure the service has been enabled/connected and is
operational.
- For adsl users please contact your Isp to make sure the service has been enabled/connected
by your Isp and that your Isp username and password is correct.
4
All manuals and user guides at all-guides.com
DIR-827