Location Of Your Washer; Rough-In Dimensions - GE GBVH6260 Manual Del Propietario E Instalación

LOCATION OF YOUR WASHER

Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2. In an area where it will come in contact with curtains
or drapes.
3. On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4"
impregnated plywood sheet solidly attached to existing
floor covering.
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0" (0 cm)
• When installed in closet: Sides, Rear,
Top = 0" (0 cm), Front = 1" (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
(7.6 cm) from top and bottom of door
Installation Instructions
), located 3"
2
13

ROUGH-IN DIMENSIONS

FRONT
27.0"
(68.6 cm)
20.4" (51.9 cm)
ELECTRONIC TRANSPARENT VISOR
SIDE
30.6"
(77.7 cm)
*NOTE: With pedestal, 52.6"
Stacked, 84"
2.2"
(5.6 cm)
40.6"*
(103.1 cm)
1.6"
(3.9 cm)
40.6"*
(103.1cm)
39.1"
(99.2 cm)