Operation; Stand Alone Operation; Dmx-Controlled Operation; Addressing - Futurelight WL-150 Manual Del Usuario

The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.

OPERATION

After you connected the effect to the mains, the WL-150 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the WL-150 can be used without controller.
Disconnect the WL-150 from the controller and from the mains and open it. Call up the internal programs as
follows:
In order order to select the programs, DIP-switch no. 10 must be set to ON, the programs are selected via
DIP-switches 1-3.
DIP-switch Program
10+1 1
10+2 2
10+1,2 3
10+3 4
10+3,1 5
10+3,2 6
10+3,2,1 7

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the WL-150 will respond to the controller.
If you set, for example, the address to channel 5, the WL-150 will use the channel 5 to 8 for control.
Please, be sure that you don't have any overlapping channels in order to control each WL-150 correctly and
independently from any other fixture on the DMX-chain.
If several WL-150 are addressed similarly, they will work synchronically.
In order order to control the device via DMX, DIP-switch no. 10 and 11 must be set to OFF, the starting
address is selected via DIP-switches 1-9.
Feature
Cyan only
Yellow only
Magenta only
CMY, fast change, short step time
CMY, fast change, long step time
CMY, slow change, short step time
CMY, slow change, long step time
22/45 51833565_V_1_3.DOC