Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
a. Install the wheels
Take the 4 wheels and the two supports.
As shown in image A, insert the wheels in the supports.
b. Install the supports
Take the wheels with the supports and two 4 mm screws from the accessories. As shown in image B, install the
wheels and supports on the bottom of the front and rear panel of the product
A
OVERHEATING SAFETY DEVICE
• The appliance is equipped with a safety device that switches off the convector in case of overheating. If the safety device
starts working, please turn off the appliance, disconnect it from the power outlet and allow it to cool completely. Inspect
the air inlet or outlet grilles to make sure they are not blocked and turn the appliance back on.
• If the appliance does not work or the safety device switches it off again, take the appliance to a service center for repair.
USE
Heating setting
The appliance incorporates a rotary switch to select different powers:
0
OFF
I
HOT AIR (500W)
II
HOT AIR (1000W)
III
HOT AIR (1500W)
Thermostat
When the convector is turned on:
1. Turn the thermostat knob fully clockwise (High)
2. When the desired room temperature has been reached, turn the thermostat knob slowly anticlockwise until you
hear a click and the operating light will go off.
3. The convector will maintain the set temperature by automatically turning on and off.
4. The red light indicates that the convector is switched on
MAINTENANCE
1. Unplug the unit and let it cool completely.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater.
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may
cause damage or deterioration to the surface of the heater.
4. DO NOT immerse the heater in water.
Wait until the unit is completely dry before use.
STORAGE
First dismantle the truckle, put the power string in the two hooks of the product bottom, then store the heater in a cool,
dry location when not in use. Preferably, to prevent dust and dirt build up, use the old packaging to repack the unit.
B
Publicidad
