Braun SyncroSystem 7570 Manual Del Usuario página 11

The shaver has to be cleaned (refer to paragraph
«Manual cleaning» or to separate «Clean&Charge» use
instructions). To reset the display, push the info key.
The shaver has to be lubricated (refer to paragraph
«Manual cleaning» or to separate «Clean&Charge» use
instructions). To reset the display, push the info key.
The shaver cannot be charged if the environmental
temperature is too low (<0 °C) or too high (>55 °C).
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
No display: The rechargeable battery is completely
discharged and has to be recharged.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose)
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard)
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to the mains via the
power supply cord set.
(If the shaver does not run immediately, charge it with the
switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
• We recommend that you shave before washing,
as the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction
of beard growth.
• Replace the shaver foil and cutter block every
1
1 / years, or when the parts are worn, to ensure
2
optimum shaving performance.
11