D-Link DCS-6112V Guía De Instalación Rápida página 10

Loosen the pan screw and turn the lens module left and right until the desired position
is achieved; tighten the pan screw once completed. Loosen the tilt screws on both
sides of the camera, and turn the lens module up and down until the desired position is
achieved; tighten the tilt screws once completed.
Loosen the image adjustment screw and turn the lens to adjust the network camera's
image until the desired orientation is achieved, tighten the image adjustment screw once
completed.
Rotate 350°
1.Align the inner side of the black cover with the notch on both sides of the lens, fix the
black Cover.
2.If you choose to the feed the cable through the ceiling or wall, arrange the cable neatly
through the cable hole. If you choose to feed the cable from the side, remove plate A.
3.Attach the dome cover to the camera as the direction shown below. With idiot-proof
mechanism design, the dome cover cannot be attached if the angle does not fit.
4.Finally, make sure all parts of the camera are securely installed.
10
DCS-6112V_6113V_A1_QIG_v1.01(DI).indd 10
5. Adjust the viewing angle
Loosen
Tilt 85°
6. Attaching the Enclosure
A
D-Link DCS-6112V/DCS-6113V Quick Install Guide
Pan 350°
Tighten
2012/3/13 下午 04:05:58