Trouble Shooting Guide; Accesories - Swissmex MX Serie Manual De Operador

Pulverizador de mochila
Ocultar thumbs Ver también para MX Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLE SHOOTING GUIDE

6.
PROBLEM
The tank collapses when pressuring it.
The piston sleeve does not run smoothly
and it is hard to pump.
The piston sleeve runs too smoothly and
it does not keep pressure.
Although the sprayer is being pumped
vigorously it does not build pressure.
When pumping a creak is produced
between the pump tube and pump
holder nut.
The shut-off valve does not close after
releasing the trigger.
The shut-off valve does not function
when depressing the trigger.
7.
ACCESSORIES
Brass spray lances (
E803-085 - 19.68" / 50 cm
E803-400 - 15.74" / 40 cm
Brass extensions (
with connector)

E219-500-C -26.3" / 67 cm
E219-510-C - 39.37" / 1.0 m
E219-520-C - 47.24" / 1.20 m
2-nozzle FVR extensions
E219-140-C - 19.6" / 50 cm
E219-147-C - 39.37" / 20 cm
E219-148-C - 28.7" / 73 cm
4-nozzle FVR extension
E219-282-C - 39.0" / 1.5 m
The breather check needs lubrication.
The agrichemical used has made the
piston sleeve to swell up.
The piston sleeve is worn out or shrunk.
The plasticball is stuck or dirt is preventing
the ball to sit properly on the ball-holder nut.
The pump tube and pump holder nut
need lubrication.
The plunger O-rings are worn out or
swollen.
The filter or nozzle are blocked.
without spray tip, nut and gasket)
E219-195-C with two nozzles,
length 19.368" / 50 cm
CAUSE
SPRAY LANCES:
FVR spray lances (
EXTENSION LANCE:
2-nozzle brass extensions
E219-098-C - 15.74" / 40 cm
3-nozzle FVR extensions
3-nozzle brass extensions
5
SOLUTION
Lubricate or replace it if it is damaged.
Replace the piston sleeve, lubricate it first.
Replace the piston sleeve, lubricate it first.
Clean the ball holder nut, and the ball,
replace them if necessary.
Lubricate both of them.
Replace them and lubricate the plunger
with the new O-rings.
Take the filter out of the shut-off valve,
clean or replace it and clean the nozzle.
without spray tip, nut and gasket)
E219-136-C - 19.68" / 50 cm
E219-142-C - 39.37" / 1.0 m
E219-143-C - 59.0" / 1.50 m
E219-146-C - 78.7" / 2.0 m
E219-138-C - 39.37" - de 1 m
E219-151-C - 59.0 de 1.5 m
219-420-C - 39.37 - 1.0 m
4-nozzle brass extension
E219-072-C - 59.0" / 1.5 m

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Mx-05Mx-06Mx-07Mx-08

Tabla de contenido