practyl 18ID1-30.1A Instrucciones Originales página 84

INTENDED USE
This machine is designed for impact drilling in brick, concrete or stone, as well as for drilling in wood and metal.
Tools with electronic control and clockwise / counter-clockwise rotation are also suitable for screwdriving.
Do not use machines, tools and accessories for additional applications (see manufacturer's instructions) or for
works other than those for which they are designed for.
The drill and screwdriver bit recommendations are to be observed.
SPECIFIC SAFETY WARNINGS
1/ Safety instructions for all operations
A. Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
B. Hold the power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory or fasteners may contact hidden wiring or its own cord. Cutting accessory or fasteners
contacting a «live» wire may make exposed metal parts of the power tool «live» and could give the operator
an electric shock.
2/ Safety instructions when using long drill bits
A. Never operate at higher speed than the maximum speed rating of the drill bit. At higher speeds, the bit is
likely to bend if allowed to rotate freely without contacting the workpiece, resulting in personal injury.
B. Always start drilling at low speed and with the bit tip in contact with the workpiece. At higher speeds, the
bit is likely to bend if allowed to rotate freely without contacting the workpiece, resulting in personal injury.
C. Apply pressure only in direct line with the bit and do not apply excessive pressure. Bits can bend causing
breakage or loss of control, resulting in personal injury.
Additional safety warnings
- Switch the power tool off immediately if the application tool becomes blocked. Be prepared for high torque
reactions which cause kickback. The application tool becomes blocked when it becomes jammed in the
workpiece or when the power tool becomes overloaded.
- Hold the power tool securely. When tightening and loosening screws be prepared for temporarily high
torque reactions.
- Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held more secure than by
hand.
- Use suitable detectors to determine if utility lines are hidden in the work area or call the local utility
company for assistance. Contact with electric lines can lead to fire and electric shock. Damaging a gas line
can lead to explosion. Penetrating a water line causes property damage or may cause an electric shock.
- Always wait until the power tool has come to a complete stop before placing it down. The application tool
can jam and cause you to lose control of the power tool.
- Hold the power tool firmly with both hands and make sure you have a stable footing. The power tool can be
more securely guided with both hands.
- In order to prevent the power tool from being switched on unintentionally, always unlock the lock on
button. To do so, briefly press the On/Off switch.
- Application tools can become hot during operation. There is a risk of burns when changing the application
tool. Use protective gloves to remove the application tool.
- Children and frail people must not use this tool. Children should be supervised at all times if they are
in the area in which the tool is being used. It is also imperative that you observe the accident prevention
regulations in force in your area.
RESIDUAL RISKS
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following
hazards may arise in connection with the tool's construction and design:
- Risk of electrocution if electric cables are drilled into – Always grasp the tool by designated handles, do not
touch the drill bits.
- Damage to the respiratory system – Wear respiratory protection masks containing filters appropriate to the
materials being worked. Ensure adequate workplace ventilation. Do not eat, drink or smoke in the work area.
- Damage to hearing – Always wear effective hearing protection and limit exposure to noise.
- Damage to eyes from flying dust and debris particles – Always wear suitable eye protection.
- Injury caused by vibration – Hold the tool by designated handles and limit exposure to vibration. See "RISK
REDUCTION".
84 - EN