Adler europe AD 9608 Manual De Uso página 4

20. Do not bend or deform perforated blade protector.
21. Exercise extreme caution when pulling out blades.
22. Wipe the shaver body with dry cloth.
23. The lint bin should be emptied when it is 3/4 full.
24. Deposit on the inner and outer surface of cutting film decreases the shaving efficiency.
Clean the film regularly with a brush.
25. Flatten the fabric surface before using the shaver.
26. Do not press the shaver in the clothing, as this may damage the fabric.
27. Do not use the shaver on the clothes that you are wearing, always remove them before
using the shaver. Otherwise the body or shaver damage may occur.
28. Always switch the shaver off before plugging in the power adaptor.
29. The shaver is equipped with a safety lock. The shaver cannot be turned on, if the film is
installed improperly or is not properly tightened.
30. Make sure not to use shaver on buttons, zippers, applications, stripes, stickers, labels,
abrasions, seams or fasteners.
31. Do not use shaver to remove lint from the silk fabrics. This can damage the fabric as
well as the shaver blades.
DESCRIPTION OF THE DEVICE
1. Safety cap
3. Blade protector
5. Rotary shaft
7. Shaver body
9. Power LED
11. Brush
CHARGING THE SHAVER
1. Make sure the shaver is switched off.
2. Connect the power cable to the shaver's power socket.
3. Connect power plug to the 220-240V ~50/60Hz electric socket.
4. Maximum charging time for completely discharged battery is 8 hours.
5. Battery lifetime will be longer, if the battery is charged only after it is completely discharged.
USING CLOTHES SHAVER
Clothes shaver is battery and mains powered. It can be powered from internal battery or directly from mains.
1. Turn the shaver on.
2. Place the clothes (fabric) on flat surface, smoothen the creasings and move the shaver forth and back along the fabric.
3. Resisting lint can be removed by moving shaver crosswise and then lengthwise (in cross-pattern) on one, small fragment of clothes.
4. You can remove pillings from thin clothing by folding it in multi layers, and putting it on flat, stiff cardboard.
5. In case of clothing with pattern, move the shaver along the pattern line.
CLEANING OF CLOTHES SHAVER
1. Turn the shaver off.
2. Remove the blade protector (3).
3. Remove blades (4) (be careful! the blades are very sharp).
4. Using the provided brush clean the blade protector (3), blades (4) and rotary shaft (5).
5. Empty the lint and pillings bin (8).
6. Assemble all removed parts in reverse order.
TECHNICAL DATA
Power supply: 220-240V ~50/60Hz
Power:5W
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
2. Removable ring
4. Blade assembly
6. Power switch
8. Lint and pillings bin
10. Power socket
4