ECOPOSTURAL C3566 Instrucciones página 14

English
grasping the upholstery or the lifting mechanism as these could be damaged.
Follow instructions at all times to avoid injury and always observe the safety procedures to move or lift the
stretcher.
The table must lean on a solid and level ground.
The chair must lean on a solid and level ground.
Notice: in certain floor surfaces the table legs might leave marks after a prolonged contact. Check the
technical specifications of the floor manufacturer to avoid any trouble.
In order to move the table around, you will need to release the castors by pressing the locking levers
downwards. To lock the castors, simply lift both locking levers upwards with your foot.
These castor wheels are only suitable for moving the table around when required, NOT
intended for patient transportation.
Before the patient lies down MAKE SURE THE CASTORS ARE LOCKED.
b) LOAD capacity
This item has been tested to support a MAXIMUM STATIC WEIGHT of 135 Kg evenly distributed all over.
* In case this weight is exceeded a safety device will automatically start-up. As a result the table might
gradually move downwards regardless of the motor activation. Reduce the load in order to restore the
proper operation of the table.
Absolutely avoid leaning on the very edge for support as it may tilt over.
If pressure on a reduced area exceeds the allowed weight, the table upholstery could split up. Keep the
patients from getting on by their knees.The maximum weight limit of every table section is 50 kg.
To get on the couch the patient must seat at the middle section. Then he can lean back.
When getting down the couch different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the couch, lean
on his side and lean forward by standing on his arms. He will then be able to put his legs out by the table's
side and easily stand up.
If the patient is lying upwards, raise the backrest and lower the leg section so that he gets back to a seated
position enabling him to go down the couch.
Caution! The back or feet section are aimed at leaning the back or feet respectively.
Never use these sections to lean forward or to sit down as the table could tilt over due
to an excessive pressure. The maximum weight support of every section is 50 kg.
c) HEIGHT adjustment
The central height of the table is operated by an electric motor.
To operate the supply cable must be plugged into a 220-230 V socket.
When raising or lowering the stretcher or when operating its modules, MAKE SURE
THAT NEITHER THE PATIENT NOR THE THERAPIST ARE TRAPPED between the
moving parts of the lifting mechanism by hands, feet or any other part of the body or
clothing. Be careful, since there is a risk of entrapment between mobile and fixed parts
of the stretcher, or, and due to unexpected movements when activating its modules.
Only operate the stretcher when there is no possibility that any part of the body could
be trapped and injured while moving the stretcher up/down or activating the tilt of the
component modules.
14