Guardian DRILL BOOT 42114 Manual De Instrucciones página 5

English
DRILL BOOT ™
WITH TETHER LOOP
Part # 42114
Instruction
Manual
Do not throw instructions away.

Read and understand instructions

before using this equipment.
Important Notes
Drill Boot™ attachments are suitable

only for cordless power tools weighing
less than 3.18 kg (7 lbs) and tool tethers
with a length of 152cm (5 ft) or less.
This product is intended for use

by personnel who are trained
and knowledgeable regarding
working with hand tools at height
and/or near machinery.
Inspect before each use for

damage and proper function:
1. Check all hardware for abrasion,
deformity, cuts and sharp edges.
2. Check for tears, cuts, fraying, abrasion,
discoloration, burns, holes, mold,
unsplicing, pulled or broken stitches,
or other signs of wear or damage.
3. Verify cord knot integrity.
4. Do not use and always quarantine if
any of the above apply or if damaged
or not functioning correctly.
Ensure the attachment location

and tool are a suitable size and
shape to support the tool in its
entirety in the event of a drop.
Safety Information
 WARNING! Do not use near
moving parts, mechanisms, running
machinery or rotating equipment.
May contain electrically

conductive materials.
Do not alter product in any way

from its original state.
Applicable Safety Standards
Meets or exceeds:
ANSI / ISEA 121-2018

Installation
See images on page 3
Step 1

Insert the drill into the drill boot
and then tighten the cinching
strap using the cord lock (A).
Step 2

Wrap the belt strap around the
front of the drill handle.
Step 3

Tighten the belt strap (B) and ensure
the pin is threaded through a hole
and excess belt is tucked.
5