Sauder Hammond Serie Instrucciones De Montaje página 13

Step 7
å
Separate the LONG EXTENSION SLIDES (2) from the LONG EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two LONG EXTENSION RAILS (1) to the other surface of the RIGHT UPRIGHT (F). Use six 5/8" FLAT
HEAD SCREWS (31).
å
NOTE: For each LONG EXTENSION RAIL, turn a SCREW into the hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT UPRIGHT. Turn a
SCREW into these holes.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull
the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(6 used in this step)
Molding
431249
31
1
www.sauder.com/service
1
Use these holes.
Closed end
1
F
7
Closed end
Closed end
Page 13