Sauder Via Serie Instrucciones De Montaje página 21

Step 17
å
Insert the dowel end of two TWIST-LOCK® FASTENERS (7F) into the
401448 Left End as shown in the enlarged diagram.
å
NOTE: If you already pushed TWIST-LOCK® FASTENERS into
the holes in the RIGHT END (A), pull the FASTENERS back out
of the holes. Pull at the front and back edges, slowly working the
FASTENERS out of the holes.
å
Push the RIGHT END (A) onto the TWIST-LOCK® FASTENERS in the
401448 Left End. Now, tighten four TWIST-LOCK® FASTENERS.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
www.sauder.com/service
L-Shape Assembly
7F
A
Finished edge
FASTENER
®
401448 Top
401448
Left End
Dowel end
401446
2
Page 21