Sauder Manhattan Gate Serie Instrucciones De Montaje página 9

Step 4
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten an EXTENSION RAIL (1) to the SMALL SPACER (L). Use three 3/8" PAN HEAD SCREWS (15).
å
NOTE: Turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
å
RAIL in to fi nd the other holes that lines up with the holes in the SMALL SPACER. Turn a SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever and pull the SLIDE from the RAIL.
Open end
These holes must be here.
429256
Open end
2
3/8" PAN HEAD SCREW
(3 used in this step)
1
www.sauder.com/service
1
Use these holes
15
L
F
7
Page 9