HQ-Power AERON 250S Manual Del Usuario página 4

• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
e) Fasteners
5. Use
a. Menu Settings
Menu
DMX address
Pan rev
Tilt rev
RSLTN
Mix colour
Lamp pow
Pan
Shutter
Dimmer
Colour
Zoom
Test Gobo 1
R-gobo
Gobo 2
Prism
R-prism
Focus
Exit
Time
Info
Version
Default
Reset
Exit
VDP250MHS18FL2_v2
Item
1 – 512
Yes
No
Yes
No
16-bit
8-bit
Yes
No
Off
On
0 – 255
Tilt 0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
0 – 255
–
1.0
Yes
No
Function
Set the required address
Backwards pan movement
Forward pan movement
Backwards tilt movement
Forward tilt movement
16-bit resolution (16 channels)
8-bit resolution (14 channels, no fine)
Mix colour function
No mix possible
Lamp OFF
Lamp ON
Pan movement test
Tilt movement test
Strobe test
Dimming test
Colour wheel test
Zoom test
Gobo wheel 1 test
R-gobo test
Gobo wheel 2 test
Prism test
R-prism test
Focus test
Exit test menu
–
Software version
Return to default setting
Keep current setting
Reset the fixture
Exit main menu
HQPOWER™