Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Risk of electric shock. When using a grounded appliance this tool will not provide an
electrical path to earth ground. Do not power devices with damaged or frayed power cords.
Insert battery pack into the powered inverter as shown. Make sure the
battery pack is secured in the powered inverter before begging operation.
Press ON/OFF button and keep 3 seconds to turn the powered inverter on.
The LED light will light up green when ready to use.
Plug device you want to power or charger into the powered inverter's USB
ports and/or 120 volt receptacle.
To use light, press the ON/OFF button. Press again to turn the light off.
Two battery packs can fit in the powered inverter at the same time, and
when one is finished, it switches to the other.
Note
: The powered inverter must be on for the worklight to function.
When finished, disconnect your devce and press and hold ON/OFF button for three seconds to
turn off the powered inverter.
Remove battery pack by depressing latch on the battery pack.
IMPORTANT CHARGING NOTES
WARNING: Battery packs are shipped in a low charge condition to prevent possible
problems. Therefore, you should charge it before first use.
•
Use only POWERSMART battery charger (Model#DB2202A)
•
Charge time is approximately 90 minutes and is dependent upon the type of battery pack.
•
Make sure the power supply is normal household voltage, 120V, AC only, 60Hz.
•
Attach the battery pack to the charger by aligning the raised ribs on the battery pack with the grooves
in the charger, then slide the battery pack onto the charger.
•
Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts
in the charger. Latches should snap into ensure charger is correctly connected.
•
Do not place the charger in an area of extreme heat or cold. It will work best at normal room
temperature.
•
The battery pack may become slightly warm to the touch while charging. This is normal and does not
indicate a problem.
•
The red LEDs will flash while charging.
•
When the green LEDs is light, this indicates the battery is fully charged.
•
To remove the battery pack from the charger, depress latches and pull up on the battery pack.
•
When the battery pack is fully charged, remove it from the charger.
MAINTENANCE
WARNING: In order to avoid personal injury and the risk of fire and electric shock,
remove the battery pack before adjusting, inspecting, or cleaning the power tool.
WARNING: When servicing, use only identical replacement parts. Use of any other parts
could create a hazard or cause product damage.
Be alert for battery packs that are nearing their end of life. If you notice decreased tool performance
or significantly shorter running time between charges, then it is time to replace the battery pack.
Failure to do so can cause the tool to operate improperly or damage the charger.
5
Publicidad
