Hilti SF 14-A Manual De Instrucciones página 20

7 Operation
en
CAUTION
The tool may get hot during use. Wear protective gloves.
CAUTION
The power tool may suddenly swing to the side (rotate about its own
axis) when drilling, hammer drilling or screwdriving. Always use the
power tool with the side handle fitted and hold it securely with both
hands.
CAUTION
To avoid injuries caused by the insert tool, wear protective gloves when
changing insert tools.
7.1 Setting forward or reverse rotation
NOTE
The forward / reverse switch is used to select the direction of rotation of the
drive spindle. An interlock prevents switching while the motor is running.
The control switch is locked when the forward / reverse switch is in the
middle position. Push the forward / reverse switch to the right (power tool
held in working direction) to select forward rotation. Push the forward /
reverse switch to the left (power tool held in working direction) to select
reverse rotation.
7.2 Adjusting the side handle
1. Release the side handle clamping band by turning the handle counter-
clockwise.
2. Pivot the side handle into the desired position.
3. Tighten the side handle by turning the handle clockwise.
4. Check that the side handle holds securely.
7.3 Speed selection using the 2-speed gear switch
WARNING
Large and heavy insert tools must only be operated in first gear. There
is otherwise a risk that the tool will be damaged when it is switched off or,
under unfavorable conditions, the chuck might be detached.
16
Printed: 30.09.2013 | Doc-Nr: PUB / 5071630 / 000 / 02
All manuals and user guides at all-guides.com
5
4
6