Bosch Relaxx'x BGS5SIL66C Instrucciones De Uso página 47

Cleaning the fluff filter
The fluff filter should be cleaned at regular intervals
in order to ensure optimum operation of the vacuum
cleaner.
26
Fig.
Open the appliance lid and remove the dust
container from the appliance.
a) Take the filter unit out of the dust container.
b) It is usually sufficient to lightly shake or tap out the
whole filter unit when the dust container is emptied
in order to dislodge any particles of dirt.
If this is not sufficient, you can use a dry cloth to
remove dirt particles from the fluff filter.
Cleaning the motor protection filter
The motor protection filter should be cleaned regular-
ly by knocking out the dirt and rinsing.
27
Fig.
a) Open the appliance lid and remove the motor pro-
tection filter.
b) Clean the motor protection filter by tapping out
the dirt. If it is very dirty, the motor protection
filter should be rinsed. Then allow the filter to dry
completely.
c) After cleaning the motor protection filter, reinsert it
into the appliance and close the appliance lid.
Cleaning the exhaust filter
The exhaust filter is designed so that it does not need
to be replaced, provided the appliance is used as
intended in the household.
To ensure that the vacuum cleaner is working at its
optimum power level, the exhaust filter should be
rinsed out after 1 year. The filtering action of the filter
remains intact, even if the filter surface becomes
discoloured.
Cleaning the HEPA filter
28
Fig.
Open the appliance lid and remove the dust
container. 18
Fig.
a) Use the locking tab to open the side flap.
b) Pull the two locking tabs to unlock the filter unit
with HEPA filter and remove it from the appliance.
c) Tap out the filter unit and rinse it under running
water.
d) Only reinsert the filter unit into the appliance after
it has dried completely and ensure that it audibly
clicks into place.
e) Close the side flap until you hear the locking tab
click into place again.
f) Insert the dust container into the appliance and
close the appliance lid.
18
Fig.
Cleaning the micro filter
29
Fig.
Open the appliance lid and remove the dust
container.
18
Fig.
a) Use the locking tab to open the side flap.
b) Pull the two locking tabs to unlock the filter unit
with foam filter and micro filter and remove it from
the appliance.
c) Remove the foam filter and micro filter from the
filter frame.
d) Foam filter and micro filter and rinse it under run-
ning water.
e) Do not re-insert the foam filter and the micro filter
into the filter frame until it has dried completely
f) Insert the filter unit in the appliance and ensure
that the locking tabs audibly click into place.
g) Close the side flap until you hear the locking tab
click into place.
h) Insert the dust container into the appliance and
close the appliance lid.
Cleaning instructions
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Caution:
Do not use a scourer, glass-cleaning agent or mul-
tipurpose cleaning product. Never immerse the va-
cuum cleaner in water.
Subject to technical modifications.
* Dependent on model
45