Polar CS102 Manual De Instrucciones página 4

EN
Installation
Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. Insert the slide-out shelf/shelves at the desired
levels and place the smaller shelf/shelves on
the floor of the appliance.
5. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
Operation
Control Panel
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Note: The Cooling Light is illuminated when
the appliance is chilling the interior cabinet.
4
CS102-CS103_GL186-GL188_GL456-GL457_ML_A5_v6_20230726.indb 4 CS102-CS103_GL186-GL188_GL456-GL457_ML_A5_v6_20230726.indb 4
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
• POLAR Back Bar Chillers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
"aux" button for 6 seconds.
• Automatic defrost cycles are every 6 hours and
last 20 minutes (factory defaults).
• To stop the Defrost, press and hold the"aux"
button for 6 seconds.
Note: If a manual defrost is started
this resets the automatic defrost timer.
During defrost periods the Defrost light is
illuminated.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
Cleaning the Condenser
• Periodically cleaning the condenser can extend
the life of the appliance.
• Note: Use a soft brush or vacuum cleaner to
clean the fins of the condenser, taking care not
to damage the fins.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
buttons to display the
2023/7/26 14:33 2023/7/26 14:33