Publicidad
Idiomas disponibles
Idiomas disponibles
Stand Installation &
Wall Mounting
Assembling / Removing the pedestal
Preparations
Take out the pedestal and the TV from the packing
case and put the pedestal onto a work table or any
other even surface.
• Use a flat and firm table or similar even surface that
can support the weight of the TV.
• Do not hold the screen panel part.
• Make sure not to scratch or break the TV.
Assembling the pedestal
1.
Place the pedestal on the table or similar even
surface.
2.
Hold the TV over the pedestal so that it coincides
with the pedestal mounting point and then lower it
to be mounted with its own weight. If the pedestal
is not fitted properly, gently press down until the
latch/es snap/s into place.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
• Put the TV onto a work table with the screen panel
down on the clean and soft cloth. Leave the pedestal
protruding over the edge of the surface.
• Press the button/s on the rear side of the pedestal
to release the latch/es.
• Remove the pedestal by pulling it away from the TV.
When using the wall mount bracket
Your TV is also prepared for a VESA-compliant wall
mount bracket. If it is not supplied with your TV, contact
your local dealer to purchase the recommended wall
mount bracket.
Stand Installation &
Wall Mounting
Assembling / Removing the pedestal
Preparations
Take out the pedestal(s) and the TV from the packing
case and put the TV onto a work table with the screen
panel down on the clean and soft cloth (blanket, etc.)
• Use a flat and firm table bigger than the TV.
• Do not hold the screen panel part.
• Make sure not to scratch or break the TV.
Assembling the pedestal
1.
Place the stand(s) on the stand mounting
pattern(s) on the rear side of the TV.
2.
Insert the screws provided and tighten them gently
until the stand is properly fitted.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
• Put the TV onto a work table with the screen panel
down on the clean and soft cloth. Leave the stand(s)
protruding over the edge of the surface.
• Unscrew the screws that fixing the stand(s).
• Remove the stand(s).
When using the wall mount bracket
Your TV is also prepared for a VESA-compliant wall
mount bracket. If it is not supplied with your TV, contact
your local dealer to purchase the recommended wall-
hanging bracket.
Antenna Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket or satellite plug to the SATELLITE
INPUT (LNB) socket located on the rear side of the TV.
Rear side of the TV
1. Satellite
2. Aerial or cable
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
English - 5 -
1
LNB
ANT
2
Publicidad
