Publicidad
Idiomas disponibles
Idiomas disponibles
English (original instruction)
Problem
Snipe (depressions at
ends of workpiece).
Torn grain
Fuzzy/rough grain.
Uneven depth of cut.
Board thickness does
not match depth scale
indicator.
44
Possible Causes
• Dull cutter blades.
• Incorrect butted stock.
• Unit not securely mounted.
• Too deep a blade setting.
• Workpiece being fed
against grain.
• Dull cutter blades.
• High wood moisture
content.
• Dull cutter blades.
• Too deep a blade setting.
• Incorrect feeding speed.
• Cutter head assembly not
level with planer surface.
• Unstable roller spring
pressure.
• Feed roller worn unevenly.
• Depth scale incorrectly set.
• Dirty planing table.
Solution
• Replace or turn cutter blades.
• Butt pieces end-to-end as they are
fed into planer.
• Tighten lag bolts.
• Reduce depth of cut.
• Feed other end of board first.
• Replace or turn cutter blades.
• Dry wood before planing.
• Replace or turn cutter blades.
• Reduce depth of cut.
• Check for adequate power supply.
Check cord and plug for damage.
Check condition of motor brushes.
• Have service performed by an
authorized service center.
• Have service performed by an
authorized service center.
• Have service performed by an
authorized service center.
• Adjust depth scale.
• Clean and wax planing table.
Publicidad
