Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Flushing the water outlets and
checking for leaks
□
Attach the handle (F) onto the valve body (D)
and turn the handle to the full on mixed position.
□
Turn on the hot and cold water supply lines,
allowing water to ow from the shower outlet (1)
until all debris is cleared from the line. Pressure
must be approximately equal on both hot and
cold sides for the valve to function properly.
Check all connections for leaks.
F
5
1
1
8
Installing the shower flange,
shower arm, and shower head
□
Insert the long end of the shower arm (B)
through the shower ange (A), then wrap thread
sealant tape around the long end of the shower
arm (B) in a clockwise direction, as shown.
□
Install the long end of the shower arm (B) into
the pipe elbow inside the wall. The shower
ange (A) should t snug to the nished wall
surface. Carefully tighten the shower arm (B)
with a clean strap wrench. Do not overtighten,
as it could cause damage to the shower arm (B).
□
Thread the shower head (C) onto the shower
arm (B). Hand-tighten only.
NOTE: Do not use the thread sealant tape and do not use
wrench to tighten shower head. If the screen lter (1) in
the spray head (C) is blocked, turn off the water supply at
angle valve and unscrew the spray head (C) from spray
arm (B). Clean the screen lter (1) in the spray head (C)
under running water with brush (2, not included).
A
B
C
C
2
1
Publicidad
