Checking And Correcting The Rotational Direction - Superrollo GW60 Instrucciones De Montaje

i
11. Checking and correcting the rotational direction
NOTE
The direction of rotation must be selected according to the type of installa-
tion (flush-mounted / surface-mounted). By default, the direction of rotation is
set for flush-mounted installation and must be corrected for surface-mounted
installations.
Please check the direction of rotation as follows for all subsequent settings:
Briefly press (UP), the belt must feed into the belt winder.
Briefly press (DOWN), the belt must feed out of the belt winder.
If the direction of rotation is correct, please proceed with chapter 12.
Correcting the direction of rotation
1.
Press an hold the SET button for
10 seconds using a sharp object
(e. g. a paper clip).
2.
Pay attention to the
indicator light
◆ The clock setting indicator light
flashes: = surface-mounted
installation
◆ You can change the direction of
rotation by pressing the button
again.
◆ The solar indicator light flashes:
= flush-mounted installation
80
Please note that the SET button
is above the arrow symbol.
Clock indicator
Solar indicator
light
EN
light