Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Step by step
Open the box, remove the material inside the cardboard and place the main frame on the floor.
Remove the plastic block holding the flywheel.
01
02
1
12
13
2
Insert the saddle post (4) into the main
frame (1), and pull the adjustment knob
(14) so that it automatically inserts into the
corresponding hole in the saddle post (4).
Secure the plastic saddle slider block (18)
and saddle slider tube (5) to the saddle post
(4) and secure them with the locking knob
(15) and washer (16). Then place the saddle
(6) on the seat sliding tube (5) and tighten
and secure it with the double bit spanner
(M13).
Note: You can loosen the knob (15) to adjust
the position of the seat sliding tube (5)
before and after adjusting it to the correct
position, but be sure to tighten the knob
(15) after adjustment. Pull the adjustment
knob (14) to adjust the height of the saddle
post (4), and after adjustment, secure the
adjustment knobs (14).
33
12
13
Use the spanner to put the screws (12) into
the washers (13). Then fix the rear Stabiliser
(2) and the front Stabiliser (3) to the main
frame (1).
Attention: The foot adjusters on the rear
stabiliser (2) and front stabiliser (3) allow
you to smoothly adjust the machine to the
3
ground. The movable wheels on the sides
of the front stabiliser (3) allow you to move
the machine a short distance.
03
6
5
18
4
16
15
1
14
EN - BESP-250
Publicidad
