Putting Into Service - HAEGER SF-16W.006A Instrucciones De Uso

Assembly instructions
The device must be completely assembled before use! While reading the text it
is advisable to refer to the "Overview of the Components".
1. Unscrew the screw form the lower pipe and insert the pipe in the round base
and tighten with the screw.
2. Loosen the connection screw and insert the head unit on the extension pipe
and fasten the connection screw.
3. Mount the rear guard to the head unit by matching the holes on the rear
guard to the round pins on the motor housing. Put the guard over the pins.
4. Secure the rear guard to the motor housing with the fastening nut for the
rear guard.
5. Put the blades onto the axle by matching the slots in the blade with the pin
on the axle; tighten the blades by turning on the fan blade locknut.
6. Test the blades by rotating with your hand. Make sure there is no friction,
when there will be some friction repeat the previous steps again.
7. Mount the front guard on the rear guard with the clips and the supplied
screw.

Putting into Service

Electrical Connection
1. Connect the device to a duly installed 220-240V~50/60Hz protective
contact socket.
2. Before inserting the plug into the socket. Make sure that the mains voltage
to be used matches that of the device. You can find this information on the
nameplate.
Use
Basic Settings
Set the blower inclination angle before starting the device. You can adjust the
inclination angle by tipping the blower casing with both hands. The inclination
angle amounts to approx. 15°.
Operating
To select the fan speed, use the selector on the front to set one of the following
speeds:
0= Turn OFF, 1 = Slow, 2 = Medium, 3 = High.
Instructions for use
English
3