Nylon Cutting Head - Makita DUR141 Manual De Instrucciones

Indication lamp
1
► 1 . Indication lamp
Indication lamp
The lamp blinks in red.
The lamp lights up in red.
(Note 1)
The lamp lights up in red.
(Note 1)
Note 1: The time at which the indication lamp lights up varies by the temperature
around the work area and the battery cartridge conditions.
Adjusting the shaft length
WARNING:
• Before adjusting the shaft length, release the switch
trigger and remove the battery cartridge from the string
trimmer. Failure to release the trigger and removing
the battery cartridge may cause a personal injury.
1
► 1 . Shaft 2. Grip
Status
This indicates the appropriate
time to replace the battery
cartridge when the battery
power becomes low.
This function works when the
battery power is almost used
up. At this time, tool stops
immediately.
Autostop due to overload.
2
Running the tool allows the indication lamp to show the
battery cartridge capacity status.
When the tool is also overloaded and has stopped
during operation, the lamp lights up in red.
Refer to the following table for the status and action to
be taken for the indication lamp.
Action to be taken
Recharge the battery cartridge
as soon as possible.
Recharge the battery cartridge.
Turn off the tool.
To adjust the length of the shaft, turn the grip counter-
clockwise until the shaft is unlocked and pull out or push
in to the desired length.

Nylon cutting head

NOTICE:
• The bump feed will not operate properly if the
Nylon cutting head is not rotating.
► 1 . Nylon cutting head
9 ENGLISH
1