iTools ITAC250A Manual De Instrucciones página 12

EN
Before starting the trimmer, make
sure that the nylon line is not touch
stones or debris.
When the trimmer is in operation,
keep the cutting section away from
all parts of the body.
Remain in a stable and secure
position while operating the
trimmer.
Keep the area being cut free from
wires, stones and debris.
Do not cut against hard objects.
This could cause injury or damage
the trimmer.
Never use the trimmer without
guard.
Be careful of the line cutting blade,
which can give deep cuts.
Do not try stop the cutting
device(nylon line) with your hands.
Always let it come to a stop by
itself.
Do not use the trimmer to cut
grass which is not in contact with
the ground; for example do not cut
grass which is on walls or rocks etc.
Do not cross roads or gravel paths
with the trimmer still running.
Always wear eye protection.
REPlACEmENT SHEET
The machine is supplied with a plug.
If the power cord is damaged,
it should be replaced by an
electrician. If you need to change
the plug, must follow the wire
connection.
12
COmPOSITION (fIG. A)
1. Switch
2. Handle
3. Body connection
4. Wire cutting edge
5. Cutting line
6. Protection
7. Cable holder
8. Plug
ASSEmBlY
NOTE:
Remove the main plug before
making any adjustments, repair or
maintenance.
INSTAllING THE
PROTECTION. (fIG. B AND
fIG. C)
CAUTION:
Never operate the machine with
a damaged protection or without
protection.
Place the guard (A) over the cutting
head and snap (B). Fit the screws
(C) to secure the protection in
place. The protection is intended
to prevent incorrect positioning,
ensuring that it is positioned
between the wire and the user (Fig.
C).
A
C
B
FIG. B
FIG. C
CONNECTION Of BODYS
(fIG. D)
Insert the bottom casing D in the
upper housing E.
Tighten the screws F.
NOTE:
Ensure the nut is located correctly
in hexagon recess.
The housing can be separated for
storage purpose.
E
FIG. D
F
D