Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Fan Operation: Always operate the fan by following all instructions and recommendations listed in this manual.
2. Fan Location: Place the fan in the area of the room that will provide proper fan cooling.
3. Fan Connection: Plug fan directly into 120-volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or fan.
Note: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other electrical needs.
Note: Some models come with a plug where you can replace a fuse. If your model has this, please read, and follow the
below instructions to replace the fuse.
This product employs overload protection (fuse). A blown fuse indicates an overload or short‑circuit situation. If the fuse
blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the product. If the replacement fuse blows, a short‑circuit may be present,
and the product should be discarded or returned to an authorized service facility for examination and/or repair.
Fuse Replacement:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades. See Fig. 2
3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful not to break
glass window.
4. Replace fuse.
WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Be sure fuse is
properly seated within its cavity. Close fuse cover by sliding it back to its original closed position.
Turning Fan On/Off: Place
fan on stable level surface.
Plug fan into properly
grounded outlet. To start
fan, pless desired speed
button 1-Low 2-Med 3-
High. Press 0-Off to
discontinue use. Unplug
fan when not in use.
Fig. 1
Fig. 2
Fig.3
~ 4
Oscillation: To start the
fan oscillation, press
Oscillation Control Knob
(located above motor
housing) down. To stop
oscillation, pull control
knob up while the fan is in
any oscillation position.
Publicidad
