Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Exemplary drawing.
AIR SUPPLY REQUIREMENTS
• Supply tool with a maximum pressure according to the technical data of this unit of clean, dry air. Higher pressure drasti-
cally reduces tool life and/or can cause several injury.
• Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
• Do not install a quick coupler directly into the air tool handle.
• In order to have the tool working to full satisfaction the minimum air delivery must be at least 10% higher than the indica-
ted air consumption of the air tool.
• Please consult the technical data in this instruction manual.
PNEUMATIC TOOL AND SAFETY INSTRUCTIONS
• The goal of Berner is to offer tools that help your work safely and efficiently.
• The most important safety device for this or any tool is YOURSELF.
• Your care and good judgment are the best protection against injury. All possible hazards cannot be considered here, but
we have tried to highlight some of the most important ones.
• This tool may only used by qualified people.
• This tool and its accessories must not be modified.
• Do not lay down the device before all the rotary parts stopped.
• Do not keep the air tool running while carrying it.
• Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces. Always use
auxiliary handle, if provided, for maximum control over kickback or torque reaction during start-up. The operator can control
torque reactions or kickback forces, if proper precautions are taken.
• Never place your hand near the rotating accessory. Accessory may kickback over your hand.
• Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and do not switch on again until
the problem is solved. Understand the reason why the tool has been blocked and make sure that this situation will not oc-
cur once more by counteract accordingly.
Publicidad
