Proline EXP1500 Manual De Instrucciones página 5

7. Set the operation knob to the brewing position (
8. The espresso coffee maker will now start operating.
9. Repeat the above for 2 to 3 cycles to ensure that possible material residues are washed out and
will not affect the taste of your espresso.
10. After use, please switch the appliance off by turning the operation knob to the OFF position
and let the appliance cool down.
MAKING ESPRESSO
1. Fill the water tank with water.
To avoid overflow, make sure the water level is not over the MAX line.
2. Fill steel mesh with ground espresso powder.
Distribute the espresso powder evenly and press it tight together using the rounded
bottom of the provided spoon.
3. Attach the metal funnel to the appliance.
Position the handle to the left of the boiler outlet, then pushing upwards and at the same
time turning the handle to the right until it locks.
4. Place a cup under the boiler outlet (It is recommended to heat the cup up before use).
5. Make sure the green indicator light is on (if it is off, wait until it illuminates), then
operation knob towards the brewing position
Once the required quantity of espresso has been obtained, stop the operation by turning
the operation knob to the OFF position.
MAKING CAPPUCCINO
IMPORTANT: Always clean steam tube and frothing device immediately after use. Check that the
steam tube is not blocked. If necessary use a needle to remove any solid milk.
1. Press the coffee/steam switch to the steam position (
2. Wait for the green indicator light to illuminate.
1
3. Fill a cup with / of milk for each cappuccino to be prepared.
3
The milk should have refrigerator temperature (should not be hot!).
When you choose the size of the cup, bear in mind that the milk volume increases by 2 to 3
times.
).
.
( )
).
turn the