Publicidad
Idiomas disponibles
Idiomas disponibles
6. LEARNING A NEW TRANSMITTER THROUGH A LEARNED ONE
The ability to learn a new remote using one already learned is linked to the type of transmitter in use. If the transmitter is not
compatible with this procedure, please refer to Chapter 4 of this manual to learn a new remote control.
Make sure the receiver is powered and ready to use (LED off).
Once press the hidden button of an already learned transmitter.
(Please refer to your transmitter instruction manual)
This corresponds to pressing the learning button on the receiver.
The LED on the receiver lights up.
Press the button of the new transmitter you want to store.
The LED will flash two times to confirm the correct storage of the remote control.
Repeat the procedure for each transmitter you want to store.
Warning: After 10 seconds of inactivity the device automatically exits the programming menu.
Attention: The receiver stores only one button per transmitter. If a second key is stored, it will replace the previously
stored key.
7. CANCELLATION OF A LEARNED SINGLE TRANSMITTER
WARNING!
This operation deletes the transmitter from all active automations in its vicinity, to which it was previously associated.
The ability to delete a single remote control is linked to the type of transmitter in use. In case the transmitter is not compatible with
this procedure, to delete the transmitter it is necessary to perform a complete reset of the memory.
Get close to the receiver from which you want to delete the transmitter.
Press and hold the hidden button of the transmitter to be deleted.
(Please refer to your transmitter instruction manual)
Without releasing the hidden button, press the first button of the transmitter.
The LED of the receiver performs 4 flashes to confirm the cancellation of the transmitter.
KEY:
6 - English
R
= LED Off;
= LED On Fixed;
= flashing LED
6-1620073M - rev.5 - 27/02/2023
R
2 x
4 x
Publicidad
