Care, Maintenance And Disposal; Troubleshooting Guide - Beurer BY 52 Manual De Instrucciones

Starting the warming process without prior warming:
1. Press the Power Button; the current warming temperature will appear on the Display. The default setting is
99 °F (37 °C).
2. To set a warming temperature, press the "+" Button repeatedly until the desired warming temperature is
displayed (between 95 °F (35 °C) and 185 °F (85 °C)). The temperature increases in steps until the display
reaches 185 °F (85 °C) and then starts over at 95 °F (35 °C).
3. Press the Power Button again to enter "Keep Warm" mode.
To exit Keep Warm mode:
1. Press and hold the Power Button for about two seconds; the Display and the bottle warmer will shut off.
2. Remove your bottle/jar using the Lifter.
3. Unplug the power cord after each usage, pour all the water out, and dry the Base with a soft, dry cloth.
NOTES:
• Shake bottles and stir foods before feeding.
• Check contents for suitable temperature.
• To prevent the spread of bacteria, which multiply fastest between 90 °F and 108 °F (32° - 42 °C), use heated
contents immediately.
• Do not keep contents warm for extended periods.
• For hygienic and microbiological reasons, do not reheat food that has already been heated.
• Do not overheat contents.

7. Care, Maintenance and Disposal

• To maximize the service life of the device, do not use it continuously in the high temperature range.
• Use boiled or filtered water for warming baby food in order to reduce the buildup of lime scale.
• Unplug the device before cleaning.
• To clean the device, use only a damp cloth. Do not use any scouring agents or other cleaning products.
• Descale the Bottle Warmer about every four weeks using vinegar or citric acid. Place the Lifter into the Base, mix
1.7 fl oz / 50 ml of household vinegar with 3.4 fl oz / 100 ml of cold water or a packet of citric acid with 6.8 fl oz /
200 ml of cold water and pour the solution into the Base. Let the solution soak until the lime scale dissolves;
do not operate the Bottle Warmer during this time. Pour the solution out, rinse the device thoroughly with clean
water, and dry it with a cloth.
Disposal
Observe the local regulations for material disposal. Dispose of the device in accordance with local regulations.
If you have any questions, please contact the local authorities responsible for waste disposal.

8. Troubleshooting Guide

Problem
Water leaks from the bottom of the
device when in use.
Warming process does not start or
does not end.
No LED Display.
The baby food warmer does not
switch on when it is plugged in.
Cause
Bottle Warmer is damaged.
Thermostat is damaged.
Power Cord not correctly plugged
in or Bottle Warmer is damaged.
No power.
5
Solution
Shut off the device immedi ately,
unplug the power cord, empty
the water, and contact Customer
Service.
Shut off the device immedi ately,
unplug the power cord, empty
the water, and contact Customer
Service.
Check that the power cord is cor-
rectly plugged in. If there is still no
display, shut off the device, unplug
the power cord, empty the water,
and contact Customer Service.
Check that the power cord is
correctly plugged into a known
working outlet.