Makita SG1251 Manual De Instrucciones página 8

NOTE:
• When the handle cannot be moved easily,
loosen the bolts furthermore.
Shifting the front handle sideways
1
► 1. Bolt (Short) 2. Cam 3. Bolt (Long)
Remove the two bolts on both sides of the front handle
with the hex wrench. Change the position of the cam.
Insert the longer bolt to the side close to the cam and the
shorter one to the opposite side. Tighten the two bolts firmly.
Connecting to vacuum cleaner
1
3
► 1. Dust nozzle 2. Vacuum cleaner 3. Hose
When using Makita dust collector, connect the hose for
the vacuum cleaner directly to the dust nozzle.
NOTE:
• The dust nozzle can be rotated freely so that
you can use it at any angle according to your
operation.
Hex wrench storage
1
► 1. Hex wrench 2. Front handle
2
2
3
2
2
When not in use, store the hex wrench to keep it from
being lost.
OPERATION
CAUTION:
1
• Be sure to pull the tool when cutting a
workpiece.
• Use this tool for straight line cutting only. Cutting
curves can cause stress cracks or fragmenta-
tion of the diamond wheels resulting in possible
injury to persons in the vicinity.
• After operation, always switch off the tool and
wait until the diamond wheels come to a com-
plete stop before putting the tool down.
• Hold the tool firmly with one hand on the switch
handle and the other hand on the front grip
when performing the tool.
Hold the tool firmly with both hands. First keep the dia-
mond wheels without making any contact with a work-
piece. Then turn the tool on and wait until the diamond
wheels attain full speed.
► 1. Notch
To cut a workpiece, pull the tool toward you (not by
pushing away from you). Align the notch on the base
with your cutting line. Push down the front handle gently
until it stops and then pull the tool slowly.
Before finishing cutting operation and raising the tool,
switch it off first. Wait until the diamond wheels stop
completely and then raise the tool.
Remove the remaining portion between the two blade
passages by other appropriate tools.
8 ENGLISH
1