Publicidad
Idiomas disponibles
Idiomas disponibles
6. Once the batteries are fully charged or the charger is not in use, unplug the charger from
the mains outlet and remove the batteries.
7. Begin again at Step 1 to charge the next set of batteries.
CAUTION
Bad Cell Detection
When the charge process is started, the charger will detect the batteries. If the batteries are
not suitable for charging (i.e. short-circuit or reversed polarity) the LED will start FLASHING
rapidly. The damaged batteries should be removed and properly disposed of.
Attention
1) This charger is designed to charge 2 or 4 batteries. 1 or 3 batteries will not get charged.
2) To charge only 2 batteries, the batteries will not get charged when placed in the below
charging slots:
8
The USB charge port takes priority over charging AA/AAA batteries. If
you have batteries inserted for charging and a device is plugged into the
USB port, charging of the AA/AAA batteries will be halted until the USB
port is no longer in use. Once the USB device is fully charged and stops
using power or it is unplugged from the USB port, the AA/AAA batteries
will resume charging automatically. The Green LED indicates when the
USB port is in use or available for use. The port has a maximum output
of 500 mA. Do not attempt to overload the USB port or damage to the
charger or USB device may result.
Slot 1+3
Slot 1+4
Slot 2+3
Slot 2+4
Publicidad
