Makita FS4000 Manual De Instrucciones página 6

Grasp the bit with a pair of pliers and pull the bit out of
the magnetic bit holder. Sometimes, it helps to wiggle
the bit with the pliers as you pull.
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the gear housing.
4
3
2
► 1. Locator 2. Bit 3. Gear housing 4. Magnetic bit
holder
Use of locator holder
1
2
► 1. Swells 2. Trapezoidal holes 3. Locator holder
The locator can be temporarily held on the locator
holder during replacing bit or using without locator. To
hold the locator, position the trapezoidal holes of the
locator on the swells of the locator holder and push it in.
1
Fit the screw on the point of the bit and place the point
of the screw on the surface of the workpiece to be fas-
tened. Apply pressure to the tool and start it. Withdraw
the tool as soon as the clutch cuts in. Then release the
switch trigger.
3
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
6 ENGLISH
OPERATION
CAUTION:
• When fitting the screw onto the point of the bit,
be careful not to push in on the screw. If the
screw is pushed in, the clutch will engage and
the screw will rotate suddenly. This could dam-
age a workpiece or cause an injury.
• Make sure that the bit is inserted straight in the
screw head, or the screw and/or bit may be
damaged.
• Hold the tool only by the handle when perform-
ing an operation. Do not touch the metal part.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.