Publicidad
Idiomas disponibles
Idiomas disponibles
Cups are not filled equally
One cup fills faster than the
other
Espresso flows too slowly or
not at all
Frothing the milk is difficult or
impossible
Pod or filter are gripped to the
machine
The machine is not working at
all
*This must be made in an authorized service facility only.
Ground coffee has not been evenly spread
in the filter
Porta-filter is not clean or is obstructed
Too much coffee in the filter, more than 7
grs
Very fine grind
There is coffee remaining in the brew-head
There is limestone in the machine
There is no water flow and the pump is
abnormally noisy
Insufficient pressure
The nozzle is obstructed
Inadequate recipient
Inadequate milk
Water flows before steam
No steam
Boiler does not heat when steam button is
pressed
There was no 15sec wait before removing
filter-holder
Incomplete connections
Machine ran out of water and safety
system has been triggered
Gently tamp the coffee
Verify/clean the porta-filter
Replace the filter holder*
Reduce the amount of coffeee
Use measuring spoon (1 spoon for each
cup)
Try another
coffee brand for espresso
Adjust the grinder level to a coarser grind
Clean the brew-head
Descale the machine as described in the
instruction manual
Check if the water tank is filled and
correctly placed
Verify pressure|replace pump*
Clean the steam nozzle
Use a tall container, preferably stainless
steel
Use cold whole milk
This is a normal procedure|allow water to
flow and place the recipient only as
steam starts
Press the steam button (when applicable)
until the temperature lamp lights up
Verify/replace thermostat*
Verify/replace resistance*
Wait for 15sec before removing the porta-
filter|when removing the porta-filter, make
some lateral pressure to let the filter or
pod fall
Check the connections
Wait 30min before using the machine
again
Publicidad
