HTC VIVE XR 2QBB100 Guía De Seguridad página 7

About Battery cradle regulatory agency identifications (Optional)
For regulatory identification purposes, VIVE battery cradle product is assigned a model number of 2QBQ100.
To ensure continued reliable and safe operation of battery cradle, use only the following accessory with your 2QBQ100:
- Battery Pack with a model number of B2QBQ100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, Rated 5 Volts DC, 3 Amp; 9 Volts DC, 3 Amp; 12 Volts DC, 2.5 Amp power supply unit.
About Battery Pack Regulatory agency identifications
For regulatory identification purposes, the Battery Pack has been assigned a model number of Headset: B2Q7Y100; Controller: B0PLH100; Battery cradle: B2QBQ100.
THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE THE DEVICE OUT OF THE BOX.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
This product is for indoor use only FCC regulations restrict the operation of this device to indoor use only. Operation prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet.
Radio Frequency Exposure Statement:
For body worn operation, this device complies with the FCC and ISED portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower output power if such function is available.
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
Prohibited for control of or communications with unmanned aircraft systems, including drones.
Innovation, Science and Economic Development Canada Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:
6