Publicidad
Idiomas disponibles
Idiomas disponibles
3
How to install Philips GoPure car air purifier in your car
3.1 Installation-placing under the car seat
(recommended position)
1. Remove liner from the
hook fastener. Avoid
touching the
adhesive side.
2. Paste the 2 strips hook
fastener at the bottom of
the device.
Important :
It is recommended to
remove any surface
contaminants that
may reduce adhesion.
Isopropyl alcohol is
a good general use
solvent for cleaning
contaminants from
surfaces for example.
3. Plug in power adaptor
to a 12V outlet in your
car. Route the cable
under your seat to the
back. Keep the cable
away from seat rails.
m Warning
For your safety, never
position the device under
the seat by sliding it from
the front of the seat.
Always slide it
underneath from the
back of the seat.
4. Connect power cable
to device and place it
underneath the car seat from
the back.
5. Press down the device
for better attachment
with the carpet.
6
3.2 Installation-using
the headrest
or armrest
1 Place the safety belt
over the device as shown,
with the furry surface
facing the device.
2 You may install Philips
GoPure car air purifier on
any headrest or armrest
of your car.
Notice:
1 The safety harness may
not be suitable to the
armrest of all car models.
2 Unpack the filter
before using
m Warning
For your safety, only use
the equipment delivered
in your package. Never
use other equipment,
such as tape, cord, or
other.
3.3 Connection and
operation
1 Connect the power
cable to the device as
shown.
2 Connect the power
adapter to a 12V outlet in
your car.
Publicidad
