Machine Start And Stop; Stopping The Machine - Clarke Vantage 17 E Instrucciones De Uso

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3. Connect the power supply plug (21) to the electrical mains.
WARNING!
Before connecting the power supply plug to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
4. To turn on the machine, turn the main switch (26) to "I".
5. Lower the squeegee (11) with the pedal (19).
6. Turn the main switch (52) to "I", to turn on the brush motor.
7. Turn the switch (53) to "I", to turn on the vacuum system motor.
8. Press the solution flow push-button (54) to change the solution quantity. Green LEDs (55) indicate the flow quantity according
to the following table:
LEDs on (55)
Setting Minimum solution flow.
9. To start scrubbing/drying, keep the hands on the handlebar (2) and start the machine by pressing the brush enabling push-
buttons (51).

Stopping the machine

10. Release the brush enabling push-buttons (51).
11. Turn the switch (53) to "0", to turn off the vacuum system motor.
12. Turn the switch (52) to "0", to turn off the brush motor.
13. To turn off the machine, turn the main switch (26) to "0".
14. Disconnect the power supply cable plug (21) from the electrical mains and place it on the holder.
15. Engage the positioning pin (24) and activate the machine transport/parking device (23a) to keep the brush/pad-holder lifted
(see Fig. 3).
16. Make sure that the machine cannot move independently.
NOTE
Each time that the machine is turned off, the solution flow program turns automatically to minimum level, to reduce water
consumption.
INSTRUCTIONS FOR USE
Medium solution flow.
9099653000 - VANTAGE 17 E
Maximum solution flow.
ENGLISH
Closed solution flow.
13