tomado Superior TDW7525B Instrucciones De Uso página 13

Placing the water filter
Open the lid of the water reservoir and place the water filter in the reservoir.
Cleaning and filling the water reservoir
Rinse the water reservoir, and therefore the appliance, prior to use.
• Snap the drip tray in place on the bottom two ridges.
• Place a large heat resistant tray or bowl under the water outlet.
• Fill the water reservoir to maximum level and press the ON/OFF button twice to switch on the appliance. The indicator led
now lights up in green. After a few seconds, there is hot water coming out of the water outlet.
• Caution: press the ON/OFF button to switch the appliance off when the tray or bowl is full. Empty the full bowl in the sink and
place it back under the water outlet.
• Press the ON/OFF button twice to switch on the appliance once more.
• Repeat these steps until the appliance has been rinsed with a full water reservoir twice.
• Fill the water reservoir with fresh cold water. The minimum water filling volume is 0.5 litres. The maximum filling volume
is 2.5 litres.
• The appliance is now ready for use.
The hot water dispenser is only suitable for boiling water. Never fill the hot water dispenser with milk, tea, coffee or other liquids.
FILLING THE HOT WATER DISPENSER
1. Open the lid of the water reservoir.
2. Fill the water reservoir of the appliance. Use a measuring cup or a water jug with fresh cold water.
3. Fill the water reservoir with maximum 2.5 litres of cold water.
4. Close the lid.
TAPPING A GLASS OR CUP OF HOT WATER
1. Place a glass or cup under the water outlet on the cup grille.
2. Press the ON/OFF button once to switch on the appliance.
- When pressed once, the indicator led lights up in blue and the appliance taps 1 cup of hot water (200 ml)
3. After a few seconds, there is hot water coming out of the water outlet.
4. If necessary, press the ON/OFF button once more to stop the water flow.
5. When filling several glasses, repeat the above steps.
When the reservoir is empty, the indicator led starts to flash in blue and green alternately. Refill the water reservoir with fresh
cold water.
Caution: The water and steam are hot and could cause burns in case of contact with your skin.
TAPPING A JUG OR LARGE MUG OF HOT WATER
1. Place a jug or mug under the water outlet on the cup grille.
2. Press the ON/OFF button twice to switch on the appliance.
- When pressed twice, the indicator led lights up in green and the appliance taps hot water continuously until you switch
it off again.
3. After a few seconds, there is hot water coming out of the water outlet.
4. Press the ON/OFF button once more to stop the water flow.
5. When filling several jugs or mugs, repeat the above steps.
USING THE APPLIANCE
EN - 13
13