Instructions Of Use; Maintenance And Cleaning; Environment Protection - Jata electro BQ101A Instrucciones De Uso

• Do not connect the appliance before making sure the plug has an adequate earth base.
• Do not leave unattended when in use.
• Use it always with the grille placed.
• VERY IMPORTANT: Never immerse in water or other liquids, the heating element, the resistance
support or the cable cord.
• Always place the appliance on heat-resistant surfaces.
• Keep away from curtains, liquids and other flammable materials.
• Make sure the cable never comes in contact with hot parts.
• Don't allow children play with the appliance. Keep the appliance out of the reach of children.
• The temperature of the metallic surfaces could be high when the appliance is working.
• Never move the barbecue when in use.
• The appliance must not be used in the open air.
• Do not use charcoal or similar combustible in this appliance.
• To unplug, pull from the plug, never from the cable.
• This appliance is not intended for using with an external timer or a separate system of remote
control.
• This appliance has been designed for domestic use only.
• If the cable were to deteriorate it must be changed by your local authorised service centre.

INSTRUCTIONS OF USE

• The grille (1) of the barbecue has two levels that allow to put the heating element (2) closer or
farther of the food to be cooked.
• The change from one to another level must be always done when the barbecue is cool.
• To put the heating element in one or another level, remove the resistance support (4) together
the heating element and the grille.
• Slide the grille to remove it and place it again in any of the levels to get one or another height
maintaining the heating element closer or farther from the food.
• Pour maximum 1/2 litre of water into the tray (3) before you connect the appliance, and verify it
does not run out while in use. Doing that you will avoid the smoke produced when falling the
grease over the tray.
• Place again the grille and the heating element with the resistance support in its original position.
VERY IMPORTANT:
• The resistance support must be perfectly fixed in its place because the appliance has a security
system to avoid start working if the resistance support is incorrectly inserted or out of its anchorage.
• When placing again the grille you must take care to assure that the two legs, which are close to
the resistance support, are placed on their seat.
• Plug in the appliance and wait a few seconds for the electrical element to heat. Then put the food
on the grille (1).

MAINTENANCE AND CLEANING

• Before you proceed to cleaning make sure the appliance is cold and that it is not connected to
the mains.
• Remember you must not immerse the electrical element and the resistance support in water.
• Remove the resistance support together the heating element and the grille.
• Use a dampened cloth to clean the resistance support and the tray.
• Do not use to clean abrasive or chemical products, metallic scourers, and such may deteriorate
the surfaces.
• The grille once removed may be cleaned with soap and water.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the
environment.
6