Publicidad
Idiomas disponibles
Idiomas disponibles
If in doubt, use the next heavier gage. The smaller the gage
number, the heavier the cord.
Minimum gage for cord sets
Total length of cord in feet (ft)
Volts
120 V - 127V
0 - 25
220 V
0 - 50
ampers
Wire gauge in square millimeters
More
No more
than
than
0
6
1,0
6
10
1,0
10
12
1,5
12
16
2,5
ADDITIONAL SAFETY INSTRUCTIONS FOR
STRING TRIMMERS
Warning:
rotate after the motor is switched off.
•
Be familiar with the controls and the proper use of the
appliance.
•
Before use, check the power supply cord and extension
cord for signs of damage, ageing and wear. If a cord
becomes damaged during use, disconnect the cord from
the mains supply immediately. DO NOT TOUCH THE
CORD BEFORE DISCONNECTING THE SUPPLY.
•
Do not use the appliance if the cords are damaged or worn.
•
Before using the appliance and after any impact, check
for signs of wear or damage and repair as necessary.
•
Always ensure that the ventilation slots are kept clear of debris.
•
Wear stout shoes or boots to protect your feet.
•
Wear long trousers to protect your legs.
•
Before using the appliance, check that your cutting path
is free from sticks, stones, wire and any other obstacles.
•
Only use the appliance in the upright position, with the
cutting line near the ground. Never switch the appliance
on in any other position.
•
Be cautious and keep your balance at all times. Stay firmly
on the slopes at all times and never run.
•
Do not work on steep slopes. Work across the face of
slopes, not up and down.
•
Move slowly when using the appliance. Be aware that
freshly cut grass is damp and slippery.
•
Never cross gravel paths or roads while the appliance is
running.
•
Before using the appliance and after any impact, check
for signs of wear or damage and repair as necessary.
•
Never touch the cutting line while the appliance is
running.
•
Do not put the appliance down until the cutting line has
come to a complete standstill.
•
Use only the appropriate type of cutting line. Never use
metal cutting line or fishing line.
•
Be careful not to touch the line trimming blade.
26 - 50
51 - 100
101 - 150
51 - 100
101 - 200 201 - 300
(mm
2
)
1,5
1,5
1,5
2,5
1,5
2,5
4,0
Not recommended
Cutting elements continue to
•
Take care to keep the mains cable away from the cutting
line. Always be aware of the position of the cable.
•
Keep hands and feet away from the cutting line at all
times, especially when switching on the motor.
•
Never operate the appliance with damaged guards or
without guards in place.
•
Take care against injury from any device fitted for
trimming the filament line length. After extending new
cutter line always return the machine to its normal
2,5
operating position before switching on.
4,0
•
Do not use the lawn trimmer (edge trimmer), if the cords
4,0
are damaged or worn.
•
Keep extension cords away from cutting elements.
ASSEMBLY AND ADJUSTMENTS
WARNING:
personal injury, turn unit off and disconnect
it from power source before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.
Assembling Upper and Lower Poles (Fig. B)
To attach the poles:
1. When installing the lower pole
align the detent lock
in Fig. B.
2. Press the two poles together so the detent lock
engages the detent slot
WARNING:
that the detent lock is completely secured in place.
If the detent lock is not completely secured it could
result in the assemblys becoming disconnected
creating a hazardous condition. Periodically check the
connections to insure that the detent lock is completely
secured in place.
Installing the Guard (Fig. C)
WARNING:
Damage or personal injury could result.
WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
1. Remove the guard screw
2. Slide the guard
Make sure the tabs
the trimmer head.
3. Continue to slide the guard on until it "snaps"into place.
The locking tab should snap into the housing slot.
To reduce the risk of serious
7
into the upper pole
8
with the detent slot
9
.
Always check to make sure
Never remove the guard.
NEVER OPERATE
15
.
13
fully onto the trimmer head
17
on the guard engage the ribs on
ENGlIsh
6
,
9
as shown
8
16
.
25
Publicidad
