Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE PROTRACTOR BASE
•
For projecting the laser beam at an angle, from 0° to 90°.
•
Remove the push pins from the storage area.
•
Place the protractor base flat against the desired surface.
NOTE: It may be helpful to place a push pin at 90° to hold the base steady while you level the base
at 0°.
Use the bubble levels to set the base horizontally at 0°.
Push a pin into the lower hole at 0°.
Turn the laser on to project the laser beam.
Pivot the laser level to set the laser beam to the desired angle.
MOUNTING WITH THE MAGNET
•
Remove the protractor base.
•
Attach the magnet to a clean metal surface.
•
Use the bubble levels to level the unit.
•
Turn the laser on to project the laser beam.
MOUNTING WITH THE SUCTION CUPS
•
For mounting to smooth surfaces.
•
Remove the protractor base.
•
Place the unit onto a smooth, nontextured surface but do not press the suction cups into place.
•
Use the bubble levels to level the unit.
•
Hold the laser level in place and press the suction cups onto a nontextured surface until they are
securely in place.
•
Turn the laser on to project the laser beam.
Note: To release suction cups from the surface, lift the tabs on the sides of the suction cups. Pulling
on the unit without first loosening the suction cups could damage the multisurface cradle.
MOUNTING WITH THE PUSH PINS
•
For securing the laser level on non-smooth surfaces.
•
Remove the protractor base.
•
Remove the push pins from the storage area.
•
Place the laser level onto the desired surface and use the bubble levels to level the unit.
•
Insert a push pin into each hole on the sides of the cradle and push the pins into the mounting
surface.
•
Turn the laser on to project the laser beam.
MOUNTING WITH THE ADHESIVE PUTTY
•
For mounting to drywall, wood, and other suitable surfaces.
•
Remove the release liner before use.
NOTE: The adhesive putty may be washed and used repeatedly. To maintain good adhesion, wash
the putty frequently. Make sure the adhesive putty is cleaned of any dust or debris before your opera-
tion.
Do not use the adhesive putty to fasten onto the wall if the wall surface is loose or wet. Always keep
the target wall surface clean.
Remove from the wall slowly after using, any residue of the adhesive putty remaining on the wall
can be cleaned by rolling the adhesive putty over the residue.
7
Publicidad
