cecotec CONGA HAND CARPET&SPOT CLEAN 2500 Manual De Instrucciones página 60

ENGLISH
How to remove the suction tube
1. Use your fingers to press down on the tabs of the cover.
2. Remove the tube in the direction of the arrows.
Installation and removal of the solids tank Fig. 5
How to remove the solids separation tank
1. Press down on the tank tab.
2. Follow the direction of the arrow and remove the tank.
How to disassemble the internal components of the solids separation tank
1. Components: tank housing, sealing gasket, bracket, mounting hole, sponge, and cover.
2. Disassembly: Remove the accessories from the tank in the following order: cover, sponge,
bracket.
3. Installation: Install the accessories in the tank in the following order: bracket, sponge,
cover.
Please note
When installing, take into account the installation holes.
4. OPERATION
1. To swtich on the vacuum cleaner, press the power button. The corresponding indicator
light will light up. Once switched on, the suction function will start, the waste-water
tank valve will open and the battery indicator light will remain lit. If you press the power
button again, the appliance and the power indicator light will turn off and the waste-
water tank valve will close after 5 seconds.
2. Press and hold the water spray button. The corresponding indicator light will light up
and the nozzle will continuously pulverise water. Release the water spray button. The
indicator light will turn off and the nozzle will stop pulverising water.
3. To activate the rotating brush function, press the motorised brush button, the
corresponding indicator light will light up. Press the button again to deactivate the
function, the indicator light will turn off.
Filling up the clean-water tank
Please note
When the water in the clean-water tank runs out, remove the tank, and fill it with water.
How to remove the clean-water tank
1. Press the clean-water tank hold button.
2. Pull the tank backwards firmly.
60
CONGA HAND CARPET&SPOT CLEAN 2500